Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?
SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: SmartSDR not reporting RF power from PGXL
I have seen this happen on my SmartSDR now and then. I reboot things and it goes back to normal. 6600, PGXL, Tuner Genius. PGXL utility reads fine. Just not the applet in the rig window. 73 Bill W9JJB1 -
Re: "Interlock" Issues with FT8 on 60M
I had an issue with the 60 m interlock until I found I had to reduce the TX bandwidth in the rig applet to below 2900 hz. At 3kz the radio would transmit outside the permissible limits. Any other par…1 -
Re: "Interlock" Issues with FT8 on 60M
My high cut is 2750 and low cut is 100. This maintains the maximum transmitted limits. My limit stops txing above 2950. Make sure your TX offsets are set to zero and the two buttons are greyed out. T…1 -
Re: PGXL app com loss
I run my station powered up 24/7. Power glitches were frustrating especially the internet modem. The Comcast modem takes about 2 minutes to reboot. First I added a simple not managed ethernet switch …1 -
Re: Distorted signal
I have had this problem for years. It is a known problem and it is easy to resolve for a few days. It is an TX overflow in the DAX driver. Most users don’t see the problem because they don’t leave th…1