Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: Off-Grid remote radio powering
Hi Larry, I am 98% Solar here so pretty close to being off Grid and the Amateur station is 100% off grid on running on Solar. The size of batteries really depends on the Duty cycle at which your runn…1 -
Re: TeensyMaestro
Lasse, Here is the BOM format they need Thanks Bret WX7Y1 -
Re: SWR HIGH RFP Error
Depending on what Radio you drive it with the TX Delay can vary a lot Try setting your TX delay IN THE RADIO to 30ms and see if the Error comes back, If it is still there try going a little higher on…2 -
Re: How do you connect an amplifier to the Flex-6500? I'm using an AL-811H
Unlike the OLD TUBE AMP's that had about 170V on the AMP key line, The Amertron AMPs have much less voltage and current usually 12V DC and a LOW current of 100ma or so but it is a good idea to p…1 -
Re: Missing FreeDV.ssdr_waveform file for FreeDV
So what kind of CAT port did you create? here is what my "Easy Setup" looks like and my CAT port setup, as you can see it uses the newer TCP type CAT port and not a COM port hope this helps…1
