Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

W2ECK ✭✭

  • Re: Log4OM & SSDR4.0.1 Install?

    W2ECKW2ECK
    Glenn Tnx for feedback - I did get it to work yesterday. For some reason one of the SmartCAT ports I had created was not working. So shifted to another previously created CAT port ad it's workin…

  • Re: 8600 & Elecraft KPA500/KAT500 Connection Help ?

    W2ECKW2ECK
    Len Found all the necessary cables and got all the pieces wired as per your diagram and Presto- it all works. KAT/KPA are following 8600 band changes and KPA is amplifying as it should. So thanks for…

  • Re: Faros & Flex 6000?

    W2ECKW2ECK
    I now have FAROS working 100% with my 6600, or working in the Flex environment. It does take a minor bit of tweaking but in the end, it works beautifully. I did exchange a few more emails with Alex V…

  • Re: SSDR - AutoZeroBeat on CW click tune

    W2ECKW2ECK
    When I first got my 6600 I asked the same question. But after using it for a few years, not sure it’s needed. When you can visually “zero beat” with your mouse , clicking right on top of the signal. …

  • Re: Editing CWX Macros?

    W2ECKW2ECK
    I found the real answer to this issue. To add or edit the CWX macros you have to go into the Flex Radio 6000 settings at the bottom mid left of the screen and NOT the SSDR for iOS settings to the rig…
Avatar