Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?
SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: split mode will not transmit
It's one of the 3.3 + Features, Sometimes you can make it work by toggling between modes. This and the loss of persistence on RX antennas making the RX ports useless keeps us on 3.2.39 at the contest…1 -
Re: SO2R: Antenna may not be changed while transmitting
Settings / Radio setup / TX tab, Set the TX Delay to 50ms and get everything working right. Then you can, if you want, decrease it to find where the issues begin and raise it a bit above that level. …2 -
Re: Workaround for antenna gain reset in 3.5.8
Alan, The way it is supposed to work, and did until 3.3 is... If you have RX A set @ +24 because you have a low gain RX antenna ANT1 (RX) set to +8 normally used on Yagi.... When you Swap between the…2 -
Re: Workaround for antenna gain reset in 3.5.8
So would an Icom. But I'd prefer that the radios just work as advertised and critical Defects stop being introduced.2 -
Re: Manually Connect to 6600M at Specific IP?
We can only Dream of having Acess to our radios like the Mac users.1