Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.

Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

---

The latest 4O3A Genius Product Software and Firmware

If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Rich McCabe ✭✭✭

• Activity
• Posts95
• Comments1.2K

• New 6600M audio issue ???

  Rich McCabe

  February 2018
  I just un-boxed my new 6600m and put it on the desk. It appears to have an audio issue. Not as noticeable in the internal speaker but even real stations are not as noticeable on that :) I am guessing…
  1

• Third time is a charm ! Thanks for Flex support.

  Rich McCabe

  March 2018
  A new 6600 to replace the previous 6600m's that I had issues with arrived yesterday. It is working flawlessly and I could not be happier with it. I was a little shocked as I took it out of the b…
  1

• CW pitch step needs to be smaller

  Rich McCabe

  March 2018
  The manual says "Clicking on the < or > buttons will decrease or increase the CW pitch frequency (tone) in 50 Hz increments" 50 hz is a pretty big step for CW pitch and the current ad…
  1

• 6600 (non M) wont boot

  Rich McCabe

  September 2018
  Went to fire up the 6600 this morning and ended up with a triple red flash showing it wont boot. Tried holding in the power button until I got the white but that did not help. Filled out a help ticke…
  1

• Is there a reason that filter knob modes are not mode specific?

  Rich McCabe

  February 2018
  Is there a reason that the knob mode for filters (High/Low and Center/Width) are not specific to operating mode? It would seem that in SSB the mode it should default to High/Low and in CW default to …
  2

Next