Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?

SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

N5NHJ ✭✭✭

  • Re: Any info for possible new Flex model?

    N5NHJN5NHJ
    As reported, those radios are referenced as BigBendModels in the FlexLib code. There is a switch/flag set to true for those models, but I haven't found any extra logic other than that.

  • Re: WKFlex - CW remote with SmartSDR and Winkeyer

    N5NHJN5NHJ
    Hi Alex, I just replied to your private e-mail. The solution to your problem is just few messages above. For your convenience I just copied it here: Some notes about K3NG Arduino CW Keyer The K3NG Ar…

  • Re: Mox- PTT remote

    N5NHJN5NHJ
    Remote PTT is fully supported by SmartSDR/SmartCAT. in SmartCAT, create a link between a real RS232 port (or USB/RS232 adapter) on your PC and SmartSDR. Connect your switch to the ground (pin 5 for a…
Avatar