Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?
SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: USB Connection from Bandmaster V to Computer and SmartSDR!
Al, Good News!! I received the Female Serial to USB Cable this afternoon. I have it set to the Kenwood Protocol and the Bandmaster V is reading the antenna's correctly. I also connected the SPE 1..3K…1 -
How to setup SDC Skimmer with a Flexradio 6400M
Good Morning, I have downloaded SDC Skimmer and installed it on my computer. I also downloaded the instruction manual also. But there doesn't seem to be any step by step instructions on setting up th…1 -
Re: CW Key Clicks
FlexRadio Admin The rise and fall times are hard coded to ensure there are no key clicks. The CW rise time is 8ms below 31wpm, and 6ms above. If you are experiencing key clicks, you will need to foll…1 -
CW Key Clicks
There has been a lot of discussion on our Club Radio Board regarding people experiencing CW Key Clicks while operating the weekend contest. Is there any setting for the 6400M that I could use to make…1 -
Re: Slice A/Slice B Issue!
Well, I guess I should have looked at the manual to begin with. You need to push the RX button on the front panel for that particular slice. Once I pushed the B slice RX button, the B line went down …1