Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: Power Genius Screen Display and Standby button not working
Dennis, The power supply was likely dislodged by very rough shipping. If you’re comfortable doing the following then this should get you going. 1. Unplug the unit 2. Remove the top cover 3. Looking a…1 -
Re: PG XL Suggestion Thread
Ross,On points #1, 2 and 3 I set the maximum RF power on the Radio | setup tab to 55 watts. I set the RF power as Larry describes above by band. That works perfectly.On point #4 pressing the round bu…1 -
Re: PGXL Fan questions
Mike,You need to use the PGXL Utility to change the fan configuration. It is not settable from the front panel.I recommend you run in standard mode unless doing almost continuous FT8 or RTTY.73,MackW…1 -
Re: SteppIR SDA2000 to Flex-6400 USB issue
Zack,I am running two SteppIR antennas here from the back of the radio. One controller is a SDA 100 and the other is a SDA 2000. Using a FTDI cable I wire it myself like the attached diagram. Note: y…1 -
Re: SteppIR SDA2000 to Flex-6400 USB issue
Retract your elements then do a calibration twice. That should fix it. Any arrows stored on the controller?1
