Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: Making a Contest Contact at 14.349
As a reminder I put permanent TNF’s at the band limits. With a roughly 3k width, they have been successful so far.1 -
Re: New Guy Questions
So basically treat it like any new radio. I suggest connecting the antenna to the “RX IN” port and a dummy load to antenna 1. This allows playing with the controls with little danger of hurting anyth…1 -
Re: Waveforms not recognized by 2.6.2.50
The iOS version of sir uses the waveform technique to run FT8, which is installed as a waveform.1 -
Re: FSK Feature Request
AND, properly done, there is no difference at the receive end, where it counts.1 -
Re: an anyone tell me if the Jetstream JTPS32MAB works with the 6600M
Angelo, I use a mfj 4230 which is equivalent to your jet stream, same ratings, same voltage adjustment, meter selections. I adjust the output voltage to 15 volts to get 14 volts at the Flex at 100 wa…1
