Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.

Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes

---

The latest 4O3A Genius Product Software and Firmware

If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Gary NC3Z ✭✭✭

• Activity
• Posts13
• Comments224

• Re: USB Cable weirdness with MultiFlex in V3

  Gary NC3Z

  April 2019
  OK Thanks Mike, wanted to make sure it was not just me and my config.
  1

• Re: 6600M using 3.0.19.119 software, can I disable the radio's panadapter?

  Gary NC3Z

  April 2019
  Or go into the 6600M's front panel's Menu and select Switch Versions to get it to log out of it's slices vs having to reboot.
  1

• MultiFlex DAX weirdness

  Gary NC3Z

  April 2019
  Another oddity with MultiFlex. If I have a RX running on the 6600M front (no DAX) and then start SSDR V3 and turn DAX on for SSDR's first RX the DAX works but the slider control for output level…
  1

• Re: 6600M front panel not always loading

  Gary NC3Z

  July 2019
  Case is open.
  1

• Re: Panadapter goes blank when pre-amp enabled

  Gary NC3Z

  July 2019
  Have you tried to move the slider on the right side of the spectrum to rescale it to more than -140dB? As you apply pre-amp gain you will see the spectrum floor go down.
  1

Next