Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
If you are having a problem, please check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need the latest SmartSDR and Power Genius Software?
SmartSDR v3.2.31 and the SmartSDR v3.2.31 Release Notes. | SmartSDR v2.6.2 and the SmartSDR v2.6.2 Release Notes.
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes. | Power Genius XL Firmware v3.5.23. | Power Genius XL Utility v2.2.10.
SmartSDR v3.2.31 and the SmartSDR v3.2.31 Release Notes. | SmartSDR v2.6.2 and the SmartSDR v2.6.2 Release Notes.
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes. | Power Genius XL Firmware v3.5.23. | Power Genius XL Utility v2.2.10.
Mike
About
- Username
- Mike
- Joined
- Visits
- 0
- Last Active
- -
- Roles
- Member
- Badges
- 0
Reactions
-
Re: Flex 6300 RF-Gain Slider
Steve: the 6300 has 2 preamp gains. None and 20 dB. Its probably working correctly. Tune in a beacon or cw signal on a low noise band, like 6 meters. Look at the signal level. It might be -100 dBm. T… (View Post)1 -
Re: Slave Slices -- idea to Synch up 2 slices
Al: I feel your pain. Using the 1500, it was never a problem as I could only see 48 kHz of spectrum. With the 6300, opened up to cover a whole band, the view around the TUNED frequency gets lost. Whi… (View Post)2 -
Re: Why isn't there a dedicated RTTY mode?
Dedicated or not, SSDR cannot be set up to operate RTTY correctly. On my low end radio, an FT-857D, the frequency display can be offset to display the RTTY Mark frequency. This is the generally recog… (View Post)2
