Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: "Interlock" Issues with FT8 on 60M
I had an issue with the 60 m interlock until I found I had to reduce the TX bandwidth in the rig applet to below 2900 hz. At 3kz the radio would transmit outside the permissible limits. Any other par…1 -
Re: "Interlock" Issues with FT8 on 60M
My high cut is 2750 and low cut is 100. This maintains the maximum transmitted limits. My limit stops txing above 2950. Make sure your TX offsets are set to zero and the two buttons are greyed out. T…1 -
Re: PGXL app com loss
I run my station powered up 24/7. Power glitches were frustrating especially the internet modem. The Comcast modem takes about 2 minutes to reboot. First I added a simple not managed ethernet switch …1 -
Re: Distorted signal
I have had this problem for years. It is a known problem and it is easy to resolve for a few days. It is an TX overflow in the DAX driver. Most users don’t see the problem because they don’t leave th…1 -
Re: 6600 reboot required to correct WSJT FT8 distortion on Transmit
To recover from this you don’t need to shut down DAX or anything else. Just click the DAX TX button to off then back on. The issue is resolved for another few days. As a matter of operation I click t…1
