Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: GPS Time on SmartSDR screen
An NTP server is not hard to do -- it's just not risen up on the priority list yet. I would recommend adding a new idea topic for this so it is not lost in the GPS time on SmartSDR screen topic.…1 -
Re: Thunderstorms, Persistence, and Remote operation - 3 Questions
Al, #1, the radio front end is "reasonably protected." With the preamp off, the radio overloads at +9dBm. Damage occurs at about +24dBm as I recall. There is a relay to disconnect the anten…1 -
Re: I'd like a CI-V or similar interface for the FLEX-6000
Ken, You are correct. It does take time to write the interface for each device so we want to pick the ones that many customers use as opposed to ones that only one or two customers might use. We have…1 -
Re: Fused power connection
There is a 30A internal fuse for the entire radio and another 3/5A fuse for the receiver-exciter board. With PowerPoles most people are using a distribution box that fuses each radio at the distribut…1 -
Re: Direct ethernet connection for FLEX-6500
The radio has Link Local support (RFC 3927) as well as automatic cable flip (MDI-X) in the Ethernet PHY. Theoretically, there should be no issue on 100BaseT based on the data sheet, but most of the t…1
