Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Mack ✭✭✭

  • Re: 6700: Assigning TX1 and TX2 to different Slices?

    MackMack
    Rich, Here is an excerpt from the Profiles manual. Yes it's possible and I run SO2R here on separate T/R antennas and 1.5 Kw amps. Transmit profiles are also linked to a TX Antenna. This means t…

  • Re: Migrating to new computer

    MackMack
    Eric, CAT setting cannot be exported since they are tied to computer hardware. Just take a screen shot of your current settings and recreate them. It shouldn't take but a few minutes. Mack W4AX …

  • SmartSDR 2.0 UPnP

    MackMack
    If you want a simple, no brains, solution to opening ports to use SmartSDR 2.0 then be sure you have Universal Plug and Play (UPnP) enabled on your router. If you do this, registering your radio for …

  • Re: 6500 power

    MackMack
    Stefano, The proper voltage is 13.8 volts at the terminals on the rear of the Flex radio when transmitting. Also, are you transmitting into a 50 ohm non inductive dummy load? Do you have an ATU disen…

  • Re: Better+CW+Options

    MackMack
    Here is the way I would solve your questions: 1. A breaking mode that is not QSK. Some times the noise between dit and dahs is a distraction, especially during rag chews. On the few occasions that I …
Avatar