Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: How doI set up a Heil PR-40 mic for my 8600? Bias on or off? Set comp? etc
The PR 40 is a dynamic mic, so bias should be off. Flex uses Controlled Envelope Single Sideband (CESSB), not audio compression, so you get a lot of punch without much distortion. If you turn on PROC…2 -
Re: Accessory connector pin 9
Funny, you asked me that question as I was already preparing an answer! To make this work, you only need the config and .hex files. The code is designed to work with multiple Flex radios on the same …1 -
Re: Multiple Logbooks?
Hi Chip, I use ACLog from N3FJP. I can run multiple instances, each with a different location, contest or any criteria that you can think of. You can then occasionally export ADIF files and aggregate…1 -
Re: CW sidetone in remote operation (nex flex-user)
Here is a link to a solution for this issue: https://community.flexradio.com/discussion/8025988/n1mm-remote-cw-sidetone-one-solution1 -
Re: The forum needs a bit of tidying up IMO
On announcements, I just click the little circle with three dots in it and select "Dismiss" so that they no longer float to the top.1
