Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: Easy Solution for Double NAT: Tailscale VPN and Smart SDR Using "Sub Net Routes"
G7UFO I have not found a direct solution to use Flex SmartLink directly with Carrier Grade NAT, as used in cell phone hot spots and StarLink. I had some success using PepLink routers, with "Pep …1 -
Re: Two instances of WSJTX?
Ok, that is a good starting point. Each instance of WSJT-X must have a unique name (Argument). In the Mac, this must be done by staring up WSJT-X from the terminal. Here are the commands I use, namin…1 -
Re: How to determine state of APF and NR
Tim It looks like you are using the Node Red Flex Node 1- Send the command "sub slice all" as Len says, this will tell the Flex to send you any changes made to a slice 2- Filter each slice.…1 -
Re: Question about TUNE button on 6600M,
Your CW pitch may have been lost causing no RF out in Tune. It will be persisted to the M client. On your M front panel, set the slice mode for “CW”. On the tx menu, ensure the CW Pitch is set for 60…1 -
Re: Acceptable SWR
Wayne Below is a well written explanation of high SWR and high power. I am not the author. It was was from a discussion on another forum on the cautions of using antenna tuners. The examples are eith…1
