Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: COM port puzzle
Guy, My best guess is that a previous program that used COM4 did not close its com port connection when the program was closed.. It may take rebooting the PC to make sure that COM4 was indeed closed …1 -
Re: Memories and Most Recently Used Frequency Utility
Remember that later .Net versions do not replace previous versions but are in addition to previous versions.. Do not uninstall previous versions of .NET unless specifically instructed during the inst…1 -
Re: Panfall out of sync with signal
Carl, Do you mean that the Waterfall lags the panadpter, or the the Waterfall lag the 6x00 RX audio or the Waterfall RX audio from another radio ?? I do not see lag in the waterfall here on my 6500. …1 -
Re: 404 errors.
Jon, go to: http://www.flexradio.com/support/downloads/ then browse to PowerSDDR/installers AL, K0VM1 -
Re: The ethernet port of my FLEX-6300 does not respond in the initial install step
Koji, I think there may be a hardware problem as the the LED should never go flashing red in a normal power up sequence.. You could try again to remove power for a couple of minutes followed by a res…1
