Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?
SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Configuring your FlexRadio "Dream Station" Equipment - FlexRadio, PGXL, TGXL, AG.
The Document regarding Configuring the FlexRadio "Dream Station" (FlexRadioi, PGXL, TGXL, Antenna Genius) has been updated to reflect the latest Software/Firmware Releases for all four piec…6 -
Re: PTT options
I made my own "thumb-Switch" with a spring-return center-off toggle switch mounted in a "Tic-Tac" mint case. Then scrounged up an RCA cable from an old VCR and used that to connec…1 -
Re: 6600M Chimes on TX
Having a low SWR on the antenna, and having Common Mode or Radiated RF entering the shack via the outside shield of the coax are completely different issues. You can have BOTH at the same time, as yo…1 -
Re: FLEX-6400: 60Hz Hum with Isolation Transformer. Resolved, But Why?
Depending upon what you had connected to the mixer, you may have had a Pin 1 problem, or you may have had a ground loop but were isolating the wrong input or output with the isolation transformer. OR…1 -
Re: Interlock is preventing Transmission AMP-TG
I had this issue immediately after updating the firmware on my TGXL and AG. It persisted until I powered everything down -- radio, amp, tuner, and AG, and turned them all back on again. It hasn't hap…1