Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?
SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: Flex6300 and SCS PTCiiiUSB Pactor Modem
We did a lot of work with the signal chains in order to be able to use Pactor with the 6000 series although it does require several settings in place. 1. You MUST be in DIGU or DIGL with a RX and TX …1 -
Re: Full-Duplex Satellite Operation on Flex-6300
With FDX enabled you should be able to listen on ANT1/ANT2 at the same time you are transmitting on XVTR. The only restriction is that you can't listen to your TX Slice audio unless the RX frequency …1 -
Re: FreeDV and VOX operation
Currently, none of the waveforms support VOX operation. The way the audio is routed to the waveform processes makes this a little tricky. We do have an issue in our tracker to address this in the fut…1 -
Re: Does the equalizer still work for the rest of you guyzzz...
Thanks for the fine bug hunting! The bug appears to be in the slice cloning logic. Whenever you click the +RX button or right-click -> Create Slice the new slice copies all the information from an…1 -
Re: Tracking Notch Filter (TNF)
You need to enable the TNFs by clicking on the TNF bottom/icon on the bottom left of the SmartSDR screen. The TNFs are bright yellow when they enabled and grey when disabled.1