Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?

SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

ZZFA COMMAND should read fractional frequency

Options
K2CM
K2CM Member ✭✭
edited February 2017 in New Ideas
The F6700 is not only a receiver; but, a spectrum analyzer too.  If the ZZFA (or new command) command were to report frequency to two decimal places, rather than to the nearest hertz, the power of the F6700 would be enhanced considerably.

Many of us use the F6700 for frequency measurements in frequency measurement tests; but, are limited in the precision that we can read from the F6700.

Frequency reading/setting to two decimals would make the F6700 into a very powerful measuring tool both for amateur and lab use.

Comments

  • Bob N7ZO
    Bob N7ZO Member ✭✭
    edited February 2017
    Options
    For FMT, I don't think any change needs to be made to the setting behavior, just increasing the readback resolution of the actual frequency set would be immensely useful (and probably much easier to implement than changing the setting behavior).

    And with GPSDO available, why limit it to two decimal places?

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.

Comment As ...

Categories