Your first Remote SmartLink SmartSDR connection -- or, how to get your remote friend connected to your radio

  • 1
  • Idea
  • Updated 7 months ago
Another video ... :)

This one is for your first SmartSDR SmartLink connection over the internet.  It is the video you can get your friend to watch so he can configure SmartSDR remotely, login and a quick walkthrough of SmartSDR.

Photo of Michael Walker

Michael Walker, Employee

  • 865 Posts
  • 251 Reply Likes

Posted 8 months ago

  • 1
Photo of Lou Dietrich

Lou Dietrich

  • 9 Posts
  • 9 Reply Likes
Mike...excellent!
Photo of AA0KM

AA0KM

  • 356 Posts
  • 65 Reply Likes
Much needed video thanks. Well done.
I guess not much to see on the physical end for now until....TBD...

Photo of Chris DL5NAM

Chris DL5NAM

  • 670 Posts
  • 152 Reply Likes
Mike, good job done !

Only a wish: speak a little bit slower sometimes and a bit louder  :-)

All none native English speaker outside US will be thankful

Merry Christmas
73 Chris DL5NAM
Photo of Michael Walker

Michael Walker, Official Rep

  • 861 Posts
  • 251 Reply Likes
Hi Chris

I don't know if I can do slow!!  Louder, I can deal with.  

Merry Christmas, Mike va3mw
Photo of Jud KE5OPL

Jud KE5OPL

  • 2 Posts
  • 0 Reply Likes
I tested my smartlink network setting with my 6300 and linksys router, and it keeps failing. I tried to setup a manual port forwarding also. It still fails. Any ideas for further troubleshooting? I have my 6300 on the LAN using a wifi extender.

works fine on the network, not remote, though. 

James KE5OPL
Photo of Jud KE5OPL

Jud KE5OPL

  • 2 Posts
  • 0 Reply Likes
I use a linksys router and bridge behind my att uverse modem/router. I had to setup both router and modem to manual port forwarding then the green test light came on. Will test later to see if I have smartlink access from internet.
...one step at a time.
Photo of Michael Walker

Michael Walker, Employee

  • 865 Posts
  • 251 Reply Likes
Hi Jud

We will need some more information to debug this.  Sorry for all the questions, but we need to start at the beginning.

Do you get a Green or Red light when you tested it?

Did you do a PTT registration?   This is part of the initial SmartLink setup.

On your Router, do you see the uPNP port forwards - there should be some page that will show the uPNP ones that are in use?

Thanks, that will help us narrow it down.

Mike