Yamaha CM500 hookup to 6600?

  • 1
  • Question
  • Updated 4 months ago
Need to connect a Yamaha CM500 headset mic to the rear panel of a 6600 (non-M). With my CM500 (no pinout diagram or mini-manual included) - box doesn't say if it's dynamic or electret, but it comes with a separate mic(?) in-line small plastic box - a 1/8" TRS female jack and a pendant 1/8" TRS plug, and it holds 2 AAA  batteries. Does this mean it's electret and this is how using the battery (bias?) box gets bias to it in a unit that's looking for a dynamic mic and provides no bias? Web search for pin-out/element type used in the CM500 hasn't helped - no joy.

Much has been written here for connections to 6300's, 6500's, 6700's, M Versions of 6400/6600, etc. and there's even a caveat about some CM500's being wired differently. And I didn't see anything about which MIC definition (Default/Heil/etc.) folks used on the 6600 with the CM500 so that all's well.

So who's using a 6600 (not M) with a fairly new CM500 and has it all working fine? Could I hear from you? rayday**at**cox **period**net.

Thanks, 73,
Ray N6HE
Photo of Ray

Ray

  • 5 Posts
  • 0 Reply Likes

Posted 4 months ago

  • 1
Photo of Craig - KØCF

Craig - KØCF

  • 148 Posts
  • 49 Reply Likes
Photo of Neal Pollack, N6YFM

Neal Pollack, N6YFM

  • 136 Posts
  • 60 Reply Likes
Hi Ray:

Yes, if it has a battery box, it is an electret.
If you decide to use the circuit at the previous post LINK, I might suggest that
for the 10 microfarad capacitor, use a NON-polarized cap.  Not a standard
electrolytic where you will need to get the polarity correct.

If you don't have one, call me and come over to my shop, I can give you one.


Cheers,
Neal Pollack
Photo of Tim K9WX

Tim K9WX

  • 39 Posts
  • 5 Reply Likes
Ray: I have a Yamaha CM500 and initially could not get it to work with my Flex.  I received my 6600 in late May and regardless of what I tried, it could not get the Yamaha to produce any TX audio from the radio.

I spent some time with it yesterday and find that my Yamaha's wiring is different than shown at:

https://community.flexradio.com/flexradio/topics/wiring-a-yamaha-cm500-headset-for-a-6400-m-or-6600-...

My CM500 was purchased in June 2014 from Amazon.  Apparently, newer purchases are wired differently. Here's what I found for mine:



So I have made an adapter cable to reflect the above pinouts and now have TX audio out of the radio.  I'm going through the process of optimizing the audio (processor, equalizer settings, etc.) and balancing the mic audio with the PC audio when using the PC as a voice keyer.

Tim K9WX

(Edited)