wsjt-x 2.0 won't decode

  • 1
  • Problem
  • Updated 4 months ago
I just down-loaded and installed wsjt-x 2.0.  I see lots of signals on the waterfall, but no audio registers in wsjt-x.  I can transmit, but no receive.  Any help would be greatly appreciated.
Photo of Andrew Thall

Andrew Thall

  • 162 Posts
  • 19 Reply Likes

Posted 4 months ago

  • 1
Photo of Rory - N6OIL

Rory - N6OIL

  • 301 Posts
  • 55 Reply Likes
If they are still on 1.9.1 you won't decode.
(Edited)
Photo of Andrew Thall

Andrew Thall

  • 162 Posts
  • 19 Reply Likes
I'm not getting any audio reading on the left-hand dB scale.
Photo of Alex - DH2ID

Alex - DH2ID, Elmer

  • 970 Posts
  • 180 Reply Likes
I assume the stations you see in the waterfall are still using 1.9.1.
Photo of Rory - N6OIL

Rory - N6OIL

  • 301 Posts
  • 55 Reply Likes
What are using for rig interface? I use OmniRig and here are my audio seetings.
Photo of Alex - DH2ID

Alex - DH2ID, Elmer

  • 970 Posts
  • 180 Reply Likes
DAX audio RX set too low?

Photo of Andrew Thall

Andrew Thall

  • 162 Posts
  • 19 Reply Likes
I'm using the settings shown by Rory and my Dax audio seems to be set just fine.
Photo of Rory - N6OIL

Rory - N6OIL

  • 301 Posts
  • 55 Reply Likes
You should see about 30db min. DAX Ch1
Photo of Andrew Thall

Andrew Thall

  • 162 Posts
  • 19 Reply Likes
The DAX control panel shows strong audio for slice A.  And I'm using DAX channel 1 but no audio gets to wsjt-x.

Photo of Rory - N6OIL

Rory - N6OIL

  • 301 Posts
  • 55 Reply Likes
Do a restart on your computer if you haven't done so already.

Photo of Andrew Thall

Andrew Thall

  • 162 Posts
  • 19 Reply Likes
I'm restarting now.  I'll let you know the results.

Photo of Andrew Thall

Andrew Thall

  • 162 Posts
  • 19 Reply Likes
That did the trick.  Thanks for the help.
Photo of Rory - N6OIL

Rory - N6OIL

  • 301 Posts
  • 55 Reply Likes
Yeah sometimes either DAX or CAT get buggered up, so I just quit everything and do a restart. Glad I was able to point you in the right direction and hope to work you on FT8. What callsign do I look for?
Photo of Andrew Thall

Andrew Thall

  • 162 Posts
  • 19 Reply Likes
My call is k2oo.  Again, thanks.