Windows 10 DDutil, flex 3000

  • 1
  • Question
  • Updated 2 years ago
  • (Edited)
I have a new computer with windows 10 pre installed :-(  SDR for flex 3000 is working fine but I can not get any of the DDutil ports to work, when I start the program it tells me I have no ports and closes the program and asked that I add a port.  How do I add a port if it just closes with a remark with add a port.  Its not crashing it just tells me to add a port then start ddutil

I have not tried to configure Audio ports yet but I am sure its going to be just as fun.

Tim just in case I have missed something do you folks at Flex have an install for windows 10 that installs all the com ports and audio ports like it did for my flex 6300?
Photo of Mike Christmas

Mike Christmas

  • 5 Posts
  • 0 Reply Likes

Posted 2 years ago

  • 1
Photo of Alex - DH2ID

Alex - DH2ID, Elmer

  • 888 Posts
  • 164 Reply Likes
I use VSPE, VAC and MiniDeluxe, all work with Windows 10 64bit and my
Flex-3000.

VSPE by eterlogic creates 2 new virtual com ports and 2 new virtual
splitter ports for me, VAC creates 2 virtual audio cables.
I can use these virtual ports for almost all digital external programs,
such as HRD, fldigi, WSJT-X, ROS, etc.pp.

Can't say anything about DDUtil, which I don't need, sorry...

Alex - DH2ID
(Edited)
Photo of Jay / NO5J

Jay / NO5J

  • 1467 Posts
  • 219 Reply Likes
DDUtil works fine with Windows 10. Your FLEX3000 should work fine with Windows 10 too. 

What are you planning to do that you haven't been able to do?

73, Jay - NO5J