What are the step to use the Hand mike with RJ-45 connection on Maestro.Ca not working on my side ?

  • 1
  • Question
  • Updated 2 years ago
  • Answered
Nothing audio with my microphone on the RJ-45 connection on my my Maestro?
Photo of Simon Lambert

Simon Lambert

  • 15 Posts
  • 1 Reply Like

Posted 2 years ago

  • 1
Photo of Chris DL5NAM

Chris DL5NAM

  • 589 Posts
  • 128 Reply Likes
What mic you using and have you selected right Mic input in config?
Photo of Mike va3mw

Mike va3mw

  • 824 Posts
  • 195 Reply Likes
The mic plugged into Mic 1 is the hand mic on the RJ45 connector.   Make sure you select Mic 1 on the Mic selection.

Don't forget, there is a manual for the Maestro

https://www.flexradio.com/downloads/maestro-user-guide-pdf/

Check page 51 part 13.2.

73

Mike va3mw
(Edited)
Photo of Simon Lambert

Simon Lambert

  • 15 Posts
  • 1 Reply Like
Thanks!I will check...
Photo of Simon Lambert

Simon Lambert

  • 15 Posts
  • 1 Reply Like
I have a Yaesu hand mike With RJ-45 connection .Normaly the pine out of the Flex are the same like Yaesu?
Photo of WX7Y

WX7Y

  • 536 Posts
  • 98 Reply Likes
The Yaesu MH-59 DTMF MIC won't work but the MH-36 does work on my Maestro, HOWEVER the PTT ground / Shield is on the wrong pin, it is on the MIC-- PIN instead of PIN7 on the RJ-45 like the manual says but seems to work OK, there is not even a wire to the FLEX GND pin on the RJ-45 on the MH-36 to tie too. 
Be sure to set MIC input to use MIC1.

good luck

Bret
WX7Y
Photo of Simon Lambert

Simon Lambert

  • 15 Posts
  • 1 Reply Like
Thank's a lot I think you have find the problem!!!

Simon-ve2sim
Photo of Simon Lambert

Simon Lambert

  • 15 Posts
  • 1 Reply Like
I Have the DTMF MH-48A6J  microphone. And the pine out look's same.I will buy a Flex microphone...