V1.3 - DDUtil doesn't seem to be getting band data on a band change

  • 2
  • Problem
  • Updated 4 years ago
Background  --  Using DDUtil to drive the frequency data to my Array Solutions Bandmaster III antenna switch and DX2400 amplifier.  

Problem - starting with V1.3.  When I switch bands using the band tab the band changes but the antenna switch and amplifier stay on the previous band until I "click tune" a signal.  

See the port monitoring snapshot below.  It appear that the frequency data continues to be sent out with the old band information.  

This is the data being sent out from DDUtil to the Bandmaster switch on COM port 4
- Band was on 80M
- 40M band is selected
- freq data continues to be for 80M until I click tune on 40M  

I also posted in the DDUtil Yahoo forum in case Steve can see anything from his end. 

Regards, Al / NN4ZZ  
al (at) nn4zz (dot) com
Photo of Al / NN4ZZ

Al / NN4ZZ

  • 1734 Posts
  • 590 Reply Likes

Posted 4 years ago

  • 2
Photo of Steve - N5AC

Steve - N5AC, VP Engineering / CTO

  • 1031 Posts
  • 1002 Reply Likes
Official Response
Steve Nance reports that he found an issue and has fixed this problem.