Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Using XVTR with 2 slice - Antenna selection

IK2HKT Stefano
IK2HKT Stefano Member ✭✭
edited May 2020 in SmartSDR for Windows
First of all sorry for my bad english but I think all of you can well understand the matter.

I am not sure if I running wrong or not ... but this is the situation:

Versione software 3.1.12
Maestro console
Flexradio 6300

Only one slice in XVTR mode (tx and rx antenna = XVTR).

I open the second slice.
When I run the second slice the RX antenna on slice 1 change from XVTR to ANT1.
(the tx antenna still remain on XVTR)

I change the slice 1 rx antenna to XVTR but, at this time, also the rx antenna on slice 2 change to XVTR antenna. (obviously the slices are running on 2 different band ! )

My question is : is this normal ? .... And, if yes, should be possible to use different rx antennas
when 2 slice running? (XVTR slice with XVTR antenna and second slice with ANT1).

I note that this is possible for TX antenna but not for RX antenna.

Maybe I have some wrong setup ?

Any help it's appreciated.

73 - Stefano IK2HKT

Answers

  • KD0RC
    KD0RC Member, Super Elmer Moderator
    edited May 2020
    Hi Stefano, yes this is normal. Even though you have two slices, there is only one reciever (spectral capture unit). You can listen to two frequencies at the same time, but they share an antenna and preamp. 73, Len, KD0RC
  • Tim - W4TME
    Tim - W4TME Administrator, FlexRadio Employee admin
    edited May 2020
    Len is 100% correct. The SCU (spectral capture unit) can only be connected to one RX antenna at a time so if you have two panadapters open and change the RX antenna of one slice, it will change the RX antenna of the other slice so that are the same.
  • IK2HKT Stefano
    IK2HKT Stefano Member ✭✭
    edited May 2020
    Thank Len .. Thank Tim.
    Obviously this is Flexradio architecture.
    All clear and thanks for your immediate answers.
    73 - Stefano IK2HKT
  • Tim - W4TME
    Tim - W4TME Administrator, FlexRadio Employee admin
    edited May 2020
    Prego

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.