USB BIT Cable and interface help PLEASE!

  • 1
  • Question
  • Updated 1 year ago
  • Answered
  • (Edited)
I've finally gotten around to building my Switch Box/Controller for my 7 transverters. 5 of the transverters work off the 28mhz Xvtr port on my 6700. The other two run off an interim 28-144 Xvtr. These are for 2304 and 3456. So, I've loaded the Beta 1.10 software with no problems. And configured it as shown in the photo. The BIT cable shows up in the menu and is enabled.

The problem I'm experiencing is.....as I select a band on the 6700 , let's say 2M, either the wrong device LED lights up for a different band OR nothing lights up or activates at all.

So does anyone, who may be familiar with this new feature, see anything out of line?

I realize a problem may exist in the hardware section but I just want to make sure the setup looks correct.

Photo of Joe - KC2TN

Joe - KC2TN

  • 96 Posts
  • 23 Reply Likes

Posted 1 year ago

  • 1
Photo of Joe - KC2TN

Joe - KC2TN

  • 96 Posts
  • 23 Reply Likes
Official Response
Well for the record, the band switching and antenna controller I was working on is complete. I wound up changing to Bit level relay boards and using the C232HM-EDHSL cable in Bit mode. It works great!




8 transverter IF's , 4 microwave antennas and all the PTT's are switched automatically via whatever program (N1MM, DXLab, etc) I'm running on my pc interfaced to my 6700 via the USB cable and running SSDR v1.10.
(Edited)