Upgraded to SmartSDR v1.10.16 and iOS v1.2 today

  • 1
  • Praise
  • Updated 2 years ago
Upgraded to the new versions of SmartSDR for both the PC (Win 7) and the iPad today. NO problems. I had 3 old versions of SSDR on the PC so I followed the instructions and un-installed them all. Then ran the new S/W and it all went well, took about 30 minutes to do both. Of course, the upgrade on the iPad was super easy, just run the update. Only thing that was a pain was the need to unplug the Flex control knob during the process. It's a pain on my PC because I have to crawl under the desk to get to the cable. Good job FLEX! 
Photo of Dave KD5FX

Dave KD5FX

  • 88 Posts
  • 4 Reply Likes

Posted 2 years ago

  • 1
Photo of Bob Craig, K8RC

Bob Craig, K8RC

  • 249 Posts
  • 98 Reply Likes
Get yourself a USB male to female extension cable and plug that into the computer. Then plug the control into the cable. That will give you a connection you can reach.

I'm great at getting down under the desk. Getting back up, not so much.