Updating to Software v 1.10.8 appears to have locked up?

  • 1
  • Question
  • Updated 2 years ago
  • Answered
I've been looking forward to updating my 6500 to the latest beta version of SSDR. However it's now been stuck on 'updating software' for 3.5 hours. Any ideas guys? I don't want to cause a problem by trying to reboot during an update?

Many thanks in adavance!
Photo of Richard - MW0XDT

Richard - MW0XDT

  • 61 Posts
  • 7 Reply Likes

Posted 2 years ago

  • 1
Photo of Kevin K4VD, Elroy

Kevin K4VD, Elroy

  • 864 Posts
  • 212 Reply Likes
Hi Richard... this is typical for some. Happened to me. A reboot of the radio and maybe restarting SSDR is all that's needed to get things rolling again. I think the explanation is that sometimes the radio gets stuck at 100% complete and needs a little help.

Kev K4VD
Photo of Mack McCormick

Mack McCormick, Elmer

  • 387 Posts
  • 135 Reply Likes
Richard,

No issues should be caused by rebooting the radio. The update may in effect be completed or you may need to run the update again.

73,

Mack
W4AX
Alpha Tester
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9153 Posts
  • 3503 Reply Likes
What Kevin and Mack said.
Photo of Richard - MW0XDT

Richard - MW0XDT

  • 61 Posts
  • 7 Reply Likes
Thanks guys, however the plot thickens....radio will not reboot?....even tried to force shut down by holding power button...still no shut down? Should I remove power?
Photo of Ria - N2RJ

Ria - N2RJ, Elmer

  • 2283 Posts
  • 925 Reply Likes
Do a reset with the OK and power button. Happened to me during the update. That's what fixed it. 

Also disconnect the USB to serial adapters during the update. 
(Edited)
Photo of Richard - MW0XDT

Richard - MW0XDT

  • 61 Posts
  • 7 Reply Likes
tricky to perform that as it's rebooting as soon as DC is applied...I'll give it a go! :-)
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9153 Posts
  • 3503 Reply Likes
Let it finish doing the firmware update on the radio.
Photo of Richard - MW0XDT

Richard - MW0XDT

  • 61 Posts
  • 7 Reply Likes
...didn't seem to work....but it has just started calibrating...hopefully it might recover now!
Photo of Richard - MW0XDT

Richard - MW0XDT

  • 61 Posts
  • 7 Reply Likes
Thanks Guys!

finally recovered, rebooted, beta version working fine now! :-)

your help much appreciated as always!

73 from Wales, Richard

This conversation is no longer open for comments or replies.