Enabling 6300 ATU via CAT commands

  • 1
  • Question
  • Updated 4 years ago
  • (Edited)
Hello,

I am wondering what is the correct CAT command sequence to simulate the TUNE button in the 6300.
In SmartSDR CAT V1.9 manual, on page 38, there is no description on the two P1 parameters that have to be sent with the TX command. (It needs a correction in next release)
From a Kenwood documents it seems P1 should be set to 2, but I'm not sure it will work and I don't want to damage anything ...
Thank a lot for your help.

73' Enzo
iw7dmh
Photo of IW7DMH, Enzo

IW7DMH, Enzo

  • 353 Posts
  • 84 Reply Likes

Posted 4 years ago

  • 1

Be the first to post a reply!