Thanks
- 46 Posts
- 1 Reply Like
Posted 5 years ago
- 146 Posts
- 35 Reply Likes
Brad,
From the Flex SmartSDR Users manual that you can download from the Flex site under Support/downloads:
http://www.flexradio.com/downloads/smartsdr-software-users-guide-pdf/
TRACKING NOTCH FILTERS
8.2 CREATING AND ADJUSTING A TRACKING NOTCH FILTER (TNF)
To create a TNF, click the button on the left side of the panadapter. This will create a TNF in the center of the panadapter. You can also right click in the panadapter or waterfall on the frequency where you would like the TNF created and select "Create TNF."
The Tracking Notch Filter will be created on the frequency where the right-click occurred. A TNF will be shown by a greenish vertical line with diagonal stripes. Once the TNF is created, the TNF may be remembered, deleted or additional notch depth may be added by right-clicking on the TNF again:
To see details on the current TNF or change its frequency or width, hover your cursor over the TNF. The cursor will change to a 4-way directional cursor and details about the TNF will appear in a callout:
To increase the width of the TNF, left-click and then move the cursor up-and-down. To adjust the frequency of the TNF, slice side-to-side. .
8.3 TURNING ON OR OFF ALL TRACKING NOTCH FILTERS (TNF)
To disable all TNFs at the same time, click on the TNF icon in the bar at the bottom on SmartSDR:
When all TNFs are disabled, the TNF icon will "gray out" as shown below. To re-enable all TNFs, just click on the button again.
Hope this helps!
Jon
W1JDB
- 249 Posts
- 42 Reply Likes
Ian
This conversation is no longer open for comments or replies.
This conversation is no longer open for comments or replies.
Related Categories
-
FLEX-6500 Signature Series SDR
- 3666 Conversations
- 951 Followers