Those using IQ router for Smartlink! Help!

  • 1
  • Question
  • Updated 9 months ago
Are (any) using UPNP in the router or did you port forward? Configuration help please?
Thanks
Photo of Reggie-k6xr

Reggie-k6xr

  • 413 Posts
  • 32 Reply Likes

Posted 9 months ago

  • 1
Photo of Kevin - KS0CW

Kevin - KS0CW

  • 89 Posts
  • 11 Reply Likes
I'm using UPnP in my IQ...
Photo of Reggie-k6xr

Reggie-k6xr

  • 413 Posts
  • 32 Reply Likes
did you have to do anything to use it? 
Photo of Matt (K0KB)

Matt (K0KB)

  • 78 Posts
  • 21 Reply Likes
UPNP in mine too. From the flex setup menu I just told it to handle the forwarding for me and it set them up in the iQ.
Photo of Kevin - KS0CW

Kevin - KS0CW

  • 89 Posts
  • 11 Reply Likes
Just made sure UPnP was enabled and the IQ is publicly reachable(found on the bottom of the IQrouter main page) 
Photo of Reggie-k6xr

Reggie-k6xr

  • 413 Posts
  • 32 Reply Likes
Evenroute had me do a router reset after they downloaded a firmware update and re-configure the router. then all worked first time with UPNP!