Temperature and fan speed Flex 6500

  • 1
  • Question
  • Updated 2 years ago
  • Answered
I have a Flex 6500 I have been using on CW for about 3 months. Running vs 1.10.16. I run 100 watts into a low SWR antenna.

Typical CW transmission 5 minutes on, 5 off, I run 30 to 35 wpm. Using DDUtil before transmission the internal temperature about 10 degrees F higher than the room. Shack typically at 70F. Flex at 80F. As I send CW the temp rises to about 125F during a 5 minute transmission then cools down over 5 minutes to about 90F than repeats up to 125F on next 5 minute transmission. Fans do not change speed as far as I can tell. 

1. Is this typical?

2. Are there any specs on when the fans will increase speed at a specific temperature?

3. Are the fans supposed to increase speed?

4. At what temperature will the Flex 6500 fail or stop transmitting?

Thanks for any information.

73,
Tom
K3TF.....
Photo of Tom K3TF

Tom K3TF

  • 71 Posts
  • 4 Reply Likes

Posted 2 years ago

  • 1
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9178 Posts
  • 3525 Reply Likes
Official Response
Answers to questions:
Q1: Reasonable.  Since airflow around the radio impacts its cooling efficiency, there isn't a "typical" value.

Q2: The chassis fans will spin up to high when the internal temp reaches 60 deg C (140 deg F)

Q3: Yes

Q4: The radio will generate an excessive thermal condition warning at 100 deg C (212 def F) and shut down at 120 deg C (248 def F).  Personally, I have no recollection of anyone every experiencing a thermal shutdown.