TCP client identification syntax "C1|client program surfacecontrol"

  • 1
  • Question
  • Updated 4 years ago

Is there a specific syntax for specifying a client name?

I have finally found the time to get deep down and dirty and start writing something using the TCP API Protocol and was just wanting to setup my program name - but alas....I get this no matter what I set it to.

C1|client program surfacepad
V1.1.0.0
H90879C4D
R1|10000002|unknown client program
M10000001|Client connected from IP 10.0.0.199

Yet if I emulate SmartSDR

C1|client program SmartSDR-Win
V1.1.0.0
H28F27383
R1|0|
M10000001|Client connected from IP 10.0.0.199

Is this for clients that are registered in the Firmware only?  if so, I will move on!


Photo of Richard Clafton W4/G7EIX

Richard Clafton W4/G7EIX, Elmer

  • 455 Posts
  • 117 Reply Likes

Posted 4 years ago

  • 1
Photo of Steve - N5AC

Steve - N5AC, VP Engineering

  • 1007 Posts
  • 971 Reply Likes
A 0x1xxxxxxx message is styled as Informational.  A 0x5xxxxxxx is an error.  So this in an informational message to let you know that the firmware has no particular knowledge of your application and will not do anything to treat it any differently ;-)

Steve
Photo of Richard Clafton W4/G7EIX

Richard Clafton W4/G7EIX, Elmer

  • 455 Posts
  • 117 Reply Likes
Thank you!