I have a SteppIR and trying to auto track using DDUtil
SO far no luck... 6 hours latter.. Installed so far includes; SDR Cat, DDUtil, USB to Serial Com port assignment
Problem 1 - (Note A) Serial Com port assigns SteppIR to Com4; which conflicts with SmartSDR Cat third party program to Port, So I used Device Manager to reassign Com 5 to SteppIR.
Ports in Device Manager are:
1- FlexRadio Virtual Serial Port Com14
2- FlexRadio Virtual Serial Port Com4
3- Prolific USB to Serial Comm Port Com3
4- Prolific USB to Serial Comm Port Com5 <<< this one keep assigning as Com4; See note A above
The only things I have set up are:
Features Tab; selected Signature; indicating Flex-6500 radio online
Ports Tab; under Passive Listener Port = Com5, Floow PSDR set to Kenwood (corresponding to Steppir controller setup), have Comm Set to 9600 8-N-1 (corresponding to Steppir controller setup); also tried using ICOM, 19200, no effect.
Others Tab; Tried setting up SteppIR; Check Enable, Port set to Comm5; negative ... when doing so, selecting Comm 5 conflicts to above Ports Tab settnig under Passive Listener Port = Com5 (so, tried clearing Passive Port, and setting Others Tab SteppIR to Comm5, steppIR window comes up, Fwd, 180, directions; negative response) gez...
FInally; I unloaded the entire setup; Flex 6500, CAT, DDUTIL, Serial to PC, et al... reloaded; negative.
Any Suggestions ????
Once I get this figured out; I have an OM2500A amp to also hookup.... cant wait... gez.