SPE 1.3k FA shows TX when starting 6500

  • 1
  • Question
  • Updated 7 months ago
  • Answered
When I turn on the amp and then turn on the radio, while the radio is going thru the calibrate sequence the amp will go into the transmit screen, it shows no output power though. 

What is up with that?
Photo of Kent Olsen

Kent Olsen

  • 12 Posts
  • 0 Reply Likes

Posted 7 months ago

  • 1
Photo of Bill English

Bill English

  • 91 Posts
  • 8 Reply Likes
I’m not sure but the most likely intelligent guess would be the TX connection closes momentarily as part of the boot process, as it’s checking out everything. I’d cure that by not turning the amp on first. It’s instant on so no warmup is needed.
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9152 Posts
  • 3478 Reply Likes
The TX Relay ports are initializing and will close momentarily on power up.  Power up the radio before the amp.
(Edited)
Photo of Kent Olsen

Kent Olsen

  • 12 Posts
  • 0 Reply Likes
Tim

Was this something new in the latest release of SSDR? It never did this before.
Photo of Sergey, R5AU

Sergey, R5AU

  • 846 Posts
  • 111 Reply Likes
The same thing in  SSDR with USB cable as BIT, configured for TX will enable TX at start of the Radio and keep initial level up to any slice are selected.
That means are Radio ON, then Transverter ON on my side.
I think necessary to find out solution independently with On/Off sequence.