SO2RDefault default profile

  • 1
  • Question
  • Updated 2 years ago
  • (Edited)
The loading of SO2RDefault profile on a 6500 following a factory reset loads two panadapters, one with a slice receiver on 20M(14.100) and the other with a slice on 40M(7.100) but both have modes set to DIGU with a slice bandwidth of 0 - 200Hz which is not a normally selectable bandwidth for DIGU and the mouse click tuning is totally off with this odd bandwidth ?

Just seems a weird default?

Do others see this?

Ray G6UJB
Photo of Ray D - G6UJB

Ray D - G6UJB

  • 37 Posts
  • 0 Reply Likes

Posted 2 years ago

  • 1
Photo of Chris Tate  - N6WM

Chris Tate - N6WM, Elmer

  • 808 Posts
  • 217 Reply Likes
Ray as far as I know  these were starter profiles set up to implement a basic starting point for settings, then you can save off your specific ones.  I agree that the raw defaults are a bit weird.  I will test this out and if needed bring it up on the alpha list as we move back into an SSDR development cycle and see if we can hone one or two default profiles to make a bit more sense.  As it stands it is a bit rough around the edges.