SmartSDR lost TX audio

  • 1
  • Question
  • Updated 2 years ago
  • Answered
  • (Edited)
Was working FD nicely with FLEX 6300 and iPad, latest software all. Then lost commercial power. On FLEX restart all seems well and normal except NO TRANSMIT AUDIO. PTT activates normally but no audio output is shown on the display.

Restarted FLEX several times from full cold. No change. Swapped out iPad for backup iPad but no change. Problem seems to be with the FLEX.

QUESTION: Should I try to correct this FLEX problem (if so what's the fix?), or just wait until next weekend and install version 2 plus the new matching iPad software to fix it? TNX -- Dave.
Photo of Dave - W6OVP

Dave - W6OVP

  • 320 Posts
  • 102 Reply Likes

Posted 2 years ago

  • 1
Photo of Ernest - W4EG

Ernest - W4EG

  • 215 Posts
  • 39 Reply Likes
Did you reload DAX and CAT? After rebooting.  I had something similar and after doing the reload, all came back to normal.
Photo of Dave - W6OVP

Dave - W6OVP

  • 320 Posts
  • 102 Reply Likes
Hello Ernest. I'll give that a try after FD is over. Did a 'factory restore' boot and now have to set it back up. TNX.
Photo of YV5WZ

YV5WZ

  • 415 Posts
  • 50 Reply Likes
remote button is on?
Photo of Dave - W6OVP

Dave - W6OVP

  • 320 Posts
  • 102 Reply Likes
Yes.
Photo of KY6LA - Howard

KY6LA - Howard, Elmer

  • 3784 Posts
  • 1637 Reply Likes
Check the mike source in the ipad App
Photo of Dave - W6OVP

Dave - W6OVP

  • 320 Posts
  • 102 Reply Likes
That was it Howard. Too obvious . Was looking elsewhere. Now for V2...

This conversation is no longer open for comments or replies.