SmartSDR IOS 2.0 persistance

  • 1
  • Problem
  • Updated 11 months ago

This was briefly discussed in another thread, thought it deserved its own to hopefully get this corrected.

Larry - W8LLL

  • 258 Posts
  • 44 Reply Likes

I am noticing no persistance after a disconnect and reconnect, keeps defaulting back to a 20 meter cw frequency. Anyone have this issue, two differant ios devices doing the same thing here.

4 days ago
Photo of Ken - NM9P

Ken - NM9P, Elmer

  • 3573 Posts
  • 1071 Reply Likes

I can confirm this, with additional information.
If I change frequency to another frequency or mode on 20 meters, then it remembers that frequency and mode.

But if I change to another band, then it returns to 20 meters after I disconnect and re-connect.

It doesn't matter if I close from the iPad and open on the iPhone, or use the same device.

Ken - NM9P
Photo of Larry - W8LLL

Larry - W8LLL

  • 372 Posts
  • 72 Reply Likes

Posted 11 months ago

  • 1
Photo of WX7Y


  • 497 Posts
  • 93 Reply Likes
I have the same issue here as well Larry so your not alone, I haven't been able to find if there is a work around or not yet.

Photo of Larry - W8LLL

Larry - W8LLL

  • 374 Posts
  • 72 Reply Likes
If others are not seeing this happen on their ios devices that would be good to know.