SmartLink works except min. waterfall. Great Battery Life

  • 1
  • Question
  • Updated 8 months ago
  • Answered
  • (Edited)

Today was the first time I was able to use my Maestro, wirelessly and battery powered.  I did notice the touch screen would except my touch to move the Panafall but would not except my touches to move the VFO.  But since it was working I kept using it.  I then tried to use VNC to login to my Shack PC but could not.  I shut down the Maestro and was able to login to my PC with VNC.  I started the Maestro (same touch screen abnormalities).  I've been using the Maestro for over 9 hours and the battery is still on Full Charge!  I don't know why it didn't work very well on previous attempts (WiFi and Battery).  Previously, the Maestro dropped out and crashed unless plugged into power and WiFi.

After running for 6 hours +, I registered my Smart Link account and went to my vehicle for a new WiFi connection.  On boot-up the Maestro displayed a message about low battery, but after connecting to my 6600 the Maestro displayed a fully charged battery.  I made a few contacts and 15 minutes later shut-down.  But while on Smart Link the waterfall operated for 1-2 second out of every 5 seconds.  The spectrum display (upper half of the panafall) was normal.

After dinner I restarted the Maestro, on battery and WiFi,  in front of the 6600 and the touch screen worked normally.

I have a Virtual Club meeting on May 3rd and I'm hoping everything works.

I will test the Maestro on Smart Link from another location this weekend.

It's 9pm, the battery suddenly died, I thought the battery symbol would indicate battery charge, it didn't, but it ran for over 10 hours!  And when it died things went haywire.  The Flex was stuck, connected to the Maestro and I couldn't break the connection.  Turned off the Flex, restarted it and all was ok to operate from SmartSDR on my Shack PC.

Photo of Steven Linley

Steven Linley

  • 13 Posts
  • 2 Reply Likes

Posted 8 months ago

  • 1
Photo of k3Tim

k3Tim

  • 849 Posts
  • 166 Reply Likes
Official Response
The touch screen of Maestro can be used to slide/move Panafall and the frequency spread but NOT the VFO. To move the VFO one can double click the area of the screen where you want to move the slice frequency.

The battery gauge can't show the amount of charge left in the power pac that one installs in the device. These output a consistent 5.0 volts and give up the ghost rather abruptly. They provide no signal for the Maestro to query.

Not sure about the stuck condition as I often disconnect a Maestro  / PC-SSDR without any problems. In fact, this is so smooth and seamless it's an impressive bit of s/w work. 

Enjoy...
k3Tim