Smartlink communication issue

  • 1
  • Question
  • Updated 6 months ago
I have been trying to use my 6600 from remote locations. I fully understand that the quality of the internet speed is key. But even hard wired at both ends and low band width connection enabled, this problems exists.

On receive, I have all green bars most of the time dipping into all yellow some of the time. I have slowed the display down as far as possible and I have perfect receive audio 100% of the time. Yes the panadapter is not perfect my any me as. But as soon as I transmit, I get about 3 to 5 seconds and the connection drops into the red sometimes down to one red bar. Release PTT and the bars go back to yellow and green. Of course all I get is reports of choppy audio.

Three computers one laptop and two surface pros all do the same thing. Since there is no RF at my remote location I know that this is not it and my QTH station works perfectly with one of these laptops.

Any ideas what to try next? My next step is to go borrow an iPad but I really don't want to carry another device when I travel.

Any help would be greatly appreciate.

Regards, mark
Photo of Mark NS9N

Mark NS9N

  • 25 Posts
  • 3 Reply Likes
  • Intrigued

Posted 6 months ago

  • 1

Be the first to post a reply!