setup wsjt-x 1.7 with 1.10.8

  • 1
  • Question
  • Updated 2 weeks ago
  • Answered
WSJT-X 1.7 looks like it is looking for an IP address for Flex6xxx.  All of the posts I can find in the community refer to older software and refer to setting up the Flex as if it was a TS-2000.  When I plug in the IP address from the radio setup panel I get an "I/O error" message.  Works fine with Commaner as middleware with the same IP address.  This may be more of a WSJT-X question but/and if anybody in the Flex community can direct me in the proper direction - much appreciated

John.
Photo of John K4SQC

John K4SQC

  • 25 Posts
  • 1 Reply Like

Posted 1 year ago

  • 1
Photo of Mario - DL3LSM

Mario - DL3LSM

  • 63 Posts
  • 23 Reply Likes
Official Response
Just a small correction: it is not the IP address of the RADIO but the IP address of the PC where SmartCAT is running.. If WSJT-X is on the same PC it would be localhost:5004 or 127.0.0.1:5004

73, Mario