selecting radio at start up

  • 1
  • Question
  • Updated 8 months ago
  • Answered
When I click on the radio to select, the update window comes up if I click on update it will remove the ver, I have which is v2.1.32 ( just got my 6400 today ) and load a previous one ( which did not do ) where do I go from here?
Photo of Don

Don

  • 48 Posts
  • 0 Reply Likes

Posted 8 months ago

  • 1
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9152 Posts
  • 3478 Reply Likes
I suspect you have a CD with version 2.1.32 and a radio that has the latest version of SmartSDR.  I recommend downloading the latest version of SmartSDR (v2.1.33) and running that on your FLEX-6400.  If it asks you to update the firmware after you connect to the radio, do so.

Here is the link to download the latest SmartSDR for Window software
http://www.flexradio.com/downloads/smartsdr_v2-1-33_installer-exe/

If you have already installed a previous version of SmartSDR on your PC, you should remove it before installing v2.1.33
Photo of Don

Don

  • 48 Posts
  • 0 Reply Likes
Tim just got the 6400 this evening and loaded the cd which says it is 2.1.32 should I download what I loaded before I download the 2.1.33?
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9152 Posts
  • 3478 Reply Likes
If you have installed SmartSDR v2.1.32 on your PC - uninstall it and reboot your PC

Download SmartSDR v2.1.33 (link previous provided), Install it and reboot when prompted.

Run SmartSDR v2.1.33 and if the Chooser indicates that the radio needs to be updated, update it.  If not, select it and connect to your radio.
Photo of Don

Don

  • 48 Posts
  • 0 Reply Likes
meant to say uninstall rather than downloads!
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9152 Posts
  • 3478 Reply Likes
Yes, see the instructions I just provided above.
Photo of Don

Don

  • 48 Posts
  • 0 Reply Likes
Thanks Tim that got me on 

This conversation is no longer open for comments or replies.