RX Audio Profile Persistence

  • 1
  • Problem
  • Updated 5 years ago
  • Acknowledged
This is a small problem, but when recalling a receive audio profile from a cold start, it seems that it is not applied to the audio chain until one of the profile gain controls is changed. The profile gain controls are persisted, but just not applied to the audio.
This was found using a 6500 with either V1.0.0 or V1.0.5 of SmartSDR

To re- create this:
1 - Save a wild RX profile you can easily hear. Leave it OFF
2 - Close SmartSDR and power down the radio.
3 - Power up the radio and start SmartSDR
4 - Listen, then turn ON the RX profile. (you will hear no change)
5 - Move any of the RX gain profile controls.
6 - You should now hear the persisted profile.

Hope that makes sense.
73 - John
Photo of W8SJV


  • 14 Posts
  • 3 Reply Likes

Posted 5 years ago

  • 1
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9152 Posts
  • 3478 Reply Likes
Official Response
I have entered this behavior in as a software defect into our bug tracker for further investigation. Thanks for the report and especially the steps to reproduce it.