RTTY Skimmer Server setup (again)

  • 1
  • Question
  • Updated 2 years ago
  • Answered
After a couple of months of sitting idle for the summer I turned my 6700 on again and promptly upgraded to v2.0.19.  After having some fun with SmartLink and then the spectrum display in N1MM+, I turned my attention to RTTY Skimmer Server.  Before shutting down for the summer everything was working great.  After the v2 upgrade, not so much.  RTTY Skimmer Server took over control of panadapters but never fired up any decoders.  It was looking like it's not getting data from the 6700 but was able to control it.

Frustration set in and I uninstalled everything and eventually even lost my working RTTY Skimmer Server config files.  I'm pretty sure I can reconstruct them though as I went through enough pain to get them working in the first place that I probably remember enough of the details.  
But, the trouble I'm having is getting RTTY Skimmer Server to even recognize the 6700 at all.  Using the skimmer/sdr command only lists the QuickSilver device where I was expecting to also see the 6700.  I do remember having to copy some files from the SDR-Bridge install to RttySkimServ directory to get things going last time.  I even found a couple of posts talking about that but they seem to be out of date.

Is there an installation procedure for all of this that I've missed? At this point I have the most recent version of SmartSDR, SDR-Bridge, RTTY Skimmer Server, and CW Skimmer Server (also not working), and CW Skimmer all installed.  Suggestions would be much appriciated!
Photo of K1DBO


  • 564 Posts
  • 120 Reply Likes

Posted 2 years ago

  • 1
Photo of Ed - W2RF

Ed - W2RF

  • 259 Posts
  • 77 Reply Likes
Official Response
Skimmer Server and RTTY Skimmer Server connect but do not decode with either SmartSDR v1.11.12 or v2.0.17. They do work with v1.10.16. I am looking into a fix. In the mean time I suggest using the working version.

73 Ed W2RF