RF Power not remembered

  • 2
  • Problem
  • Updated 4 years ago
Occasionally when I add a new slice, the RF Power is not remembered or retrieved properly and it goes to full power 100 watts.   This is a real problem when using an amp.  I love persistence but it really needs to be consistent.   

Along these same lines.  Say I add a couple slices to a Pan Adapter, 14.300 and 14.292 on 20 meters, then I switch band to say 40 meters.  When I eventually come back to 20 meters the slices may or may not be there.   I then go to add a slice back to my 20 meters and the darn RF Power defaults to 100 watts.   My amp only requires 18 watts for full output power.   This is not a good situation and I can't trust SmartSDR persistence.

Norm - KL7RS
Photo of Norm S

Norm S

  • 64 Posts
  • 3 Reply Likes

Posted 4 years ago

  • 2
Photo of DrTeeth

DrTeeth

  • 1687 Posts
  • 387 Reply Likes
This drives me nuts too. What is set in the setup tab for the tuning power should stick. Sri to bump an old thread, but this issue is still present.