Remote start is disabled by default when upgrading to 1.10.8 Beta

  • 1
  • Problem
  • Updated 2 years ago
  • Solved
Not a big general problem, and it's resolved this time, but it was a big problem for me when I tried to upgrade to the new Beta SW remotely. I operate one of my 6500s locally in North Carolina and another 6500 remotely in Illinois (and vice versa depending on where I am). I access both either with my Maestro or SSDR so actually I can operate two stations in two locations simultaneously.

As posted in a separate thread, I upgraded flawlessly using the Maestro locally (in NC). Very simple.

But when I tried to upgrade Illinois, I bricked my remote system and could not connect to the Illinois 6500. (NC still worked FB locally).

After an 800 mile drive to investigate (OK ... I was going home anyway :-) I traced the problem to a restart. I restart by enabling REMOTE and then power cycling. I discovered that the DEFAULT settings when upgraded have the REMOTE setting DISABLED. Therefore, when the radio was power cycled during the upgrade my radio was waiting for my magic finger to physically restart the radio.

So the update went well, but when it rebooted, I could not remotely restart because of the disabled REMOTE setting. When I got home and physically pressed the front panel start button, all was well. "Problem" resolved. 

It would be nice if the settings could transfer to new SW upgrades (especially REMOTE!). Nice in the sense that it would save me gas. 

73,
Fred
K9SO
Photo of Fred GLENN

Fred GLENN

  • 61 Posts
  • 7 Reply Likes

Posted 2 years ago

  • 1
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9152 Posts
  • 3478 Reply Likes
Official Response
This particular caveat was well documented in the Important Release Details section of the release notes for SmartSDR v1.10.8, especially the concerns with updating remotely.  This is why it is always a best practice to completely read the release notes before upgrading your radio to a new version of firmware.

I have reprinted the paragraph.

If you operate your radio remotely, please read this before upgrading.  As a result of correcting defect #4046, where the power LED would incorrectly indicate the presence of a GPSDO, the setting for the Remote On feature has been reset to its default state (disabled).  If you are using the Remote On feature of the radio, you will need to change it back to enabled once you have upgraded to SmartSDR v1.10.8.  Upgrading the radio remotely may result in the radio not rebooting after the upgrade if the Remote On feature is required.