Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

Relay Chatter on 6M when the ATU is pretuned and enabled

W8SJV
W8SJV Member
With the ATU engaged on 6M USB, there is a rapid relay chatter at about 20-30Hz on voice peaks when transmitting. Using the tune button gives the same result above about 6 watts or so. This sounds like RF feedback into a control circuit, but only is SSB modes. If the ATU is left on and then you switch to CW the chatter does not occur, even with full power. I'm not sure if this relates to the reported CW tune problem or not. If the ATU is in bypass mode no chatter is seen in any mode. Tests were performed both on a good 6M antenna and dummy load.
Tagged:

Comments

  • Tim - W4TME
    Tim - W4TME Administrator, FlexRadio Employee admin
    edited March 2017
    I am converting your problem report into a HelpDesk Support ticket so we can troubleshoot your problem one-on-one.
  • Tim - W4TME
    Tim - W4TME Administrator, FlexRadio Employee admin
    edited March 2017
    This topic has been solved in Zendesk

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.