Radio control for the Flex6300

  • 1
  • Question
  • Updated 4 years ago
I am building a automatic loop controller to interface to my Flex-6300 to read the Frequency but not sure how to build a cable to connect to the back of the radio. Any help/suggestions will be appreciated.

Thanks
Peter
Photo of Peter

Peter

  • 79 Posts
  • 5 Reply Likes

Posted 4 years ago

  • 1
Photo of KY6LA - Howard

KY6LA - Howard, Elmer

  • 3471 Posts
  • 1335 Reply Likes
Not too sure what you mean by Automatic Loop Controller

But DDUTIL will probably do that for you via serial port on the computer
Photo of Peter

Peter

  • 79 Posts
  • 5 Reply Likes
My controller will read the frequency of the radio and tune the capacitor on the magnetic loop antenna. What I am looking for is basically how to use the connector on the 6300 to make a cable as the manual is not very clear on the pin out.
Photo of Sergey, R5AU

Sergey, R5AU

  • 802 Posts
  • 96 Reply Likes
Peter, no way with you idea, acces via Ethernet only, this is not a COM port based radio. Let`s take more powerfull controller with LAN and proceed via APIĀ 
(Edited)